Sometimes it seems like you’re not getting enough vapor & you don’t see to be receiving fluid from the electronic cigarette atomizer. If you Just keep adding fluid that won’t solve the problem. It is in fact the problem itself.

One method you can get rid of the excess fluid from the electric cigarette atomizer is to get something thats good at absorbing. This stuff works great, it’s an old brown shopping bag paper, they also call it craft paper, a newspaper works good & a paper towel as well, If you can tear a small piece off of it & its absorbant then use it. Then you may want to roll it up into a small tube. What you want is a tube that is just large enough to fit in the end of the electronic cig atomizer. You don’t want to push it in too much to break your vapor cigarette atomizer. Now you can vape normally. You can tilt your electronic cig up (the LED light facing upwards) this is done to make the E juice flow down. Take a few vape. Eventually it will taste dry.

Now lets grab the brown piece of paper you used prior (or any paper towel or any absorbent liquid item). Now it should be nice and dry in there. Grab your bottle of E liquid and use the E liquid to drip carefully and slowly along the outside of the wall inside of the cartridge to avoid the center hole. so just drip it along the side of the wall, be certain to rotate along the outside of the cartomizer wall in order to make sure every bit of the stuffing is moisten. You’ll notice the E cig cartomizer is full when the liquid starts to flood of the E liquid at the top of the cartomizer. Go ahead and take your rubber stopper and put it back in. Not only will this rubber stopper stop the pooling, but it will compact it. Now place it back on your battery, It’s that simple, now you’re ready to smoke.